RDF System Management Manual for H-Series RVUs (RDF 1.8)

Recovery Delete some of the volumes.
Too many volumes are specified in this ALTER command
Cause You specified too many volumes in the command parameter list of an ALTER
command.
Effect The ALTER command aborts.
Recovery Eliminate some of the volumes from the command parameter list.
Triple Contingency CopyAudit command aborted.
Cause The COPYAUDIT command has aborted because of a problem reported in the
previous RDFCOM message.
Effect The COPYAUDIT command aborts.
Recovery Correct the problem reported in the previous error message and reissue the
COPYAUDIT command.
Unable to allocate Map
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The NEWPROCESS procedure fails.
Recovery Make sufficient space available on the swap volume for the requested operation.
Unable to communicate with CPU cpu
cpu
is the CPU that is not responding.
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The NEWPROCESS procedure fails.
Recovery Check the status of the CPU, or enter SET and ALTER commands to direct the
process to run on a different CPU.
Unable to get MAT filename with sequence number seq-num from the TMP;
search stopped.
seq-num
is the sequence number of the MAT file.
Cause RDFCOM could not obtain the fully qualified name of the audit-trail file with the
specified sequence number from the TMP.
Effect RDFCOM terminates the search for a TMF shutdown timestamp and then its attempt
to initialize RDF.
Recovery Check to see if TMF is started:
• If it is not, start TMF before you again attempt to initialize RDF.
• If it is running and this error occurs, this is an internal error. Contact the Global Mission
Critical Solution Center (GMCSC) or your service provider.
Unable to obtain the process access id of RDFCOM
Cause RDFCOM could not obtain the process access id of the user who started the RDFCOM
session.
Effect The ADD command fails.
Recovery Exit RDFCOM and then try again. If the problem persists, contact the Global
Mission Critical Solution Center (GMCSC) or your service provider.
Unable to purge old image file due to error error# DELETE ABORTED
error#
is the file-system error number that identifies the specific error.
RDFCOM Messages 427