RDF System Management Manual for H-Series RVUs (RDF 1.8)

Effect The command fails.
Recovery Scan the EMS event log to determine why the command could not be performed.
Correct the error condition, if possible, and request the update operation again.
VOLUME device is NOT a disk volume
device
is the non-disk device assigned to the updater.
Cause The RDF configuration file is invalid.
Effect RDF will not start.
Recovery Change the RDF configuration to reflect a valid disk volume.
VOLUME device UPDATEVOLUME is NOT a disk volume
device
is the non-disk device assigned for the UPDATEVOLUME.
Cause The RDF configuration file is invalid.
Effect RDF will not start.
Recovery Change the RDF configuration to reflect a valid disk volume.
VOLUME Record exists, use ALTER VOLUME volume
Cause An ADD VOLUME command was issued when the configuration file already
contained an updater record for the volume.
Effect The RDF command fails.
Recovery No recovery is required if you want to use the existing updater process as it is
configured. If you want to change any of the updater’s configuration options, however, enter
an ALTER VOLUME command that specifies those changes.
VOLUME volume contains too many physical volumes The SMF pool cannot
contain more than 15 volumes
volume
is the offending SMF virtual disk
Cause The updater is configured to a virtual SMF disk that consists of more than 15 physical
disks. This configuration is not supported by the RDF product.
Effect RDF will not start.
Recovery Reset your RDF configurations and/or your SMF configuration so that the updaters
are either assigned to physical volumes, or your SMF virtual disks map to 15 or fewer physical
volumes.
VOLUME volume does NOT exist
volume
is the volume on the primary node for which the updater is responsible.
Cause The RDF configuration file is invalid.
Effect RDF will not start.
Recovery Bring the volume up or delete it from the RDF configuration.
VOLUME volume is NOT configured within TMF
volume
is the volume on the primary node for which the updater is responsible.
Cause The RDF configuration file is invalid.
Effect RDF will not start.
Recovery Delete the volume from the RDF configuration or add the volume to the TMF
configuration.
RDFCOM Messages 429