RDF System Management Manual for H-Series RVUs (RDF 1.8)

Cause You entered a COPYAUDIT command and receive this message as a prompt for
confirmation that you want to proceed with the command’s execution.
Effect If you respond YES or Y, RDF executes the command. If you respond NO or N, the
command terminates.
Recovery This is an informational message; no recovery is required.
You are about to unpin a file that the extractor needs. Are you sure
you want to proceed?
Cause You have asked RDFCOM to unpin a file that is currently needed by the extractor.
If you respond “yes,” the file is unpinned and TMF can rename it. If the file is renamed, RDF
cannot be restarted until you restore the file.
Effect RDFCOM suspends until you respond to the prompt.
Recovery Respond “yes” or “no” to the prompt.
You are attempting a TAKEOVER operation immediately after the receiver
has crashed. Please contact your HP analyst before proceeding with the
TAKEOVER operation.
Cause RDFCOM has detected that the receiver stopped prematurely the last time it was
running. Because you are attempting the takeover operation before RDF has been allowed to
restart, the probability is high that your database is already inconsistent with respect to
transaction boundaries. That is, for some transactions, all audit data might not have been
applied to database.
Effect The database might be inconsistent.
Recovery Performing the takeover might still leave the database inconsistent. If you
nevertheless choose to perform the takeover operation, you must first manually repair the last
image file on disk. Before proceeding, contact the Global Mission Critical Solution Center
(GMCSC) or your service provider.
You are logged on as user-id. To issue this command you must be super-id.
Cause You tried to issue a critical RDFCOM command, but you are not the super-user who
initialized the RDF configuration.
Effect The command fails.
Recovery Log on as the super-user who initialized your RDF configuration.
You cannot add more than 48 network records
Cause The current limit for the number of RDF subsystems in your RDF network is 48 and
you have attempted to add 49.
Effect The configuration command fails.
Recovery Do not add any more network records.
You cannot alter MAPFILE on the backup system if the primary system is
available
Cause During execution of an ALTER VOLUME command on the backup system, RDFCOM
determined that the primary system is accessible.
Effect The command fails.
Recovery Reenter the command on the primary system.
You cannot alter MAPLOG on the backup system if the primary system is
available
Cause During execution of an ALTER VOLUME command on the backup system, RDFCOM
determined that the primary system is accessible.
Effect The command fails.
Recovery Reenter the command on the primary system.
RDFCOM Messages 433