RDF System Management Manual for H-Series RVUs (RDF 1.8)

You cannot START RDF after an RDF Takeover operation.
Cause You tried to start RDF after an RDF takeover operation has been performed.
Effect The START RDF command fails.
Recovery You must initialize RDF on the primary system. You should also ensure that the
takeover operation completed successfully.
You cannot start updaters before the extractor has completed Phase 2
of its online database synchronization operation.
Cause You tried to start updaters by either a START RDF or START UPDATE command
before the extractor completed Phase 2 of its database synchronization operation.
Effect The START RDF or START UPDATE command fails.
Recovery You must wait until the extractor has logged message 782 before starting the
updaters. You can, however, issue a START RDF, UPDATE OFF command.
You have not added the master EXTRACTOR yet
Cause You tried to add an auxiliary extractor before adding the master extractor.
Effect The ADD command fails.
Recovery You must add the master extractor first.
You have not added the master RECEIVER yet
Cause You tried to add an auxiliary receiver before adding the master receiver.
Effect The ADD command fails.
Recovery You must add the master receiver first.
You must specify the year with four digits
Cause You specified the year in a timestamp with less than four digits.
Effect The command involving the timestamp fails.
Recovery Reissue the command, specifying a four-digit year in the timestamp.
RDFSCAN Messages
The following RDFSCAN messages (listed alphabetically by text) can appear on your terminal
screen during an RDFSCAN session.
Beyond eof!
Cause The AT position specified is beyond the end-of-file mark in the current log file.
Effect The AT command fails.
Recovery Reenter the AT command, this time with a record-number parameter that
indicates a position before the end-of-file mark.
Error error# attempting to open the help file
error#
is the file-system error number that identifies the specific error.
Cause A file-system error occurred while RDFSCAN was trying to open the HELP file,
RDFSCANH.
Effect The HELP command fails.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the HELP command. Otherwise,
see your system manager.
Error error# trying to open logfile, filename
434 Messages