RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Example
To initiate updating on the backup system of all volumes protected by RDF, enter:
]START UPDATE
STATUS
The STATUS command displays current configuration information and operational statistics for the
RDF environment, or specified portions thereof. All forms of the STATUS command, except STATUS
RTDWARNING, automatically include information and statistics for the monitor process.
STATUS {MONITOR } [, PERIOD seconds[, COUNT repeat]]
{RDF }
{EXTRACTOR }
{RECEIVER }
{PURGER }
{PROCESS procname }
{VOLUME }
{RTDWARNING }
{RDFNET }
MONITOR
requests information and statistics for the monitor process. All STATUS commands display
details for the RDF monitor process except the STATUS RTDWARNING command.
RDF
requests information and statistics for the entire RDF environment.
EXTRACTOR
requests information and statistics for the extractor process.
RECEIVER
requests information and statistics for the receiver process.
PURGER
requests information and statistics for the purger process.
PROCESS procname
requests information and statistics for the specified process.
VOLUME
requests information and statistics for all configured updater processes.
RTDWARNING
requests information and statistics for only those processes (the extractor or any updater) that
have fallen behind the configured RTD threshold (rtd-time). For information about setting
that threshold, see the SET RDF command. Each time this command is issued and a process is
displayed because it has fallen behind the RTD warning threshold, an EMS event is generated
for that process.
RDFNET
requests information and statistics for the RDFNET process.
PERIOD seconds
specifies the interval in seconds between successive executions of the command.
COUNT repeat
specifies how many times to execute the particular STATUS command. If you omit the COUNT
repeat option but include the PERIOD seconds option, the command is executed repeatedly
at the specified time intervals until you press the BREAK key.
Where Issued
Primary or backup system.
RDFCOM Commands 233