RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
The receiver has successfully completed its initialization.
Effect
The receiver is prepared to receive data from the extractor.
Recovery
This is an informational message; no recovery is required.
772
TMF is not running on the remote system
Cause
The receiver has determined that TMF is not started on the RDF backup system.
Effect
The receiver abends.
Recovery
Start TMF on the backup system and then restart RDF.
773
Remote RDF updater started vol => vol
vol => vol
are the volume on the primary node that the updater is protecting and the corresponding
volume to which it is writing on the backup node.
Cause
The updater has successfully completed its initialization. The message includes the audited volume
name and its corresponding update volume name.
Effect
The updater is prepared to apply updates to the database on the backup node.
Recovery
This is an informational message; no recovery is required.
774
Local RDF extractor started
Cause
The extractor has successfully completed its initialization.
Effect
The extractor will begin reading TMF audit data and transmitting it to the receiver.
Recovery
This is an informational message; no recovery is required.
775
Restart position adjusted for database synchronization
Cause
The extractor has encountered a restart condition during an online database synchronization
operation, and its current audit trail restart position sent by the receiver might lead to loss of
data.
Effect
The extractor revises its restart location to an earlier point in the audit trail, thereby guaranteeing
that no data will be lost.
368 Messages