RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

filename
is the name of the exception file.
Cause
An updater is unable to apply image records for some transactions because a TAKEOVER
command was executed and the commit, abort, or data records for the transactions were not
sent to the backup system. The message includes the name of the exception file containing
information about the image records that were not applied.
Effect
If all the records for a transaction are not received on the backup node, the transaction is treated
as if it aborted. For every image record that is not applied to the backup database, an exception
record is written to the designated exception file.
Recovery
This is a normal occurrence during TAKEOVER processing. The system manager can use
RDFSNOOP to list the image records that were not applied to the backup database. The backup
database will be consistent after the TAKEOVER operation, but some transactions that might
have committed on the primary system might not be applied to the backup database.
781
RDF extractor transaction status table overflow
Cause
The extractor’s transaction status table that is used for online database synchronization operations
has overflowed. This has happened because more than 650,000 transactions were started
during the first TMP control point interval following the RDFCOM STOP SYNCH command, and
these transactions are still active.
Effect
The extractor abends.
Recovery
You must initialize RDF to a new database synchronization timestamp and then restart the entire
operation from the beginning.
782
Phase two database synchronization complete
Cause
Phase two of the database synchronization involving the process generating this message has
completed.
Effect
If the process is the extractor, then all operations performed by the extractor for the database
synchronization are complete, although the updaters might not have completed their work on
the backup system.
If the process is an updater, then the backup database is synchronized for the volume protected
by the particular updater.
Recovery
This is an informational message; no recovery is required.
783
RDF receiver process is not running
Cause
The monitor or extractor process could not open the remote receiver process after a
communications failure.
370 Messages