RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Effect
If the monitor or extractor process receives a file-system error 14 (process does not exist), RDF
will shut down on the primary node.
Recovery
If RDF was stopped on the remote node by a STOP RDF command while the communications
lines were down, simply restart RDF by issuing a START RDF command.
784
Shutdown pending STOP UPDATE, TIMESTAMP timestamp
timestamp
is the specified timestamp.
Cause
The process has received notice that an RDFCOM STOP UPDATE, TIMESTAMP command was
executed.
Effect
Each updater applies only audit data associated with transactions that committed prior to the
specified timestamp.
Recovery
This is an informational message; no recovery is required.
785
Redo pass ending on reaching timestamp timestamp
timestamp
is the timestamp specified previously by an operator in an RDFCOM STOP UPDATE,
TIMESTAMP timestamp command.
Cause
A STOP UPDATE, TIMESTAMP timestamp command has been issued and the updater has
completed its redo pass.
Effect
The updater is ready to commence its undo pass.
Recovery
This is an informational message; no recovery is required.
786
STOP SYNCH message received
Cause
The extractor has received notification of the RDFCOM STOP SYNCH command. This event
represents the start of part one of phase 1 of the extractor’s work in an online database
synchronization operation.
Effect
When the extractor encounters the next TMP control point record in the MAT, it enters phase
one, part 1 processing.
Recovery
This is an informational message; no recovery is required.
787
Image trail file position error error on filename. SNO sno RBA rba
error
is the error number that identifies the specific error.
RDF Messages 371