RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

filename
is the name of the image trail file that contained the error.
sno
is the sequence number where the error occurred.
rba
is the relative byte address where the error occurred.
Cause
The receiver or an updater has encountered the indicated error while attempting to position into
an image file.
Effect
The process abends.
Recovery
Correct the problem that caused the error and then restart RDF.
788
ALLOCATESEGMENT failure. Returned status status
status
is a status code reflecting information about the error.
Cause
An RDF process received an error from the ALLOCATESEGMENT system procedure.
Effect
This is a catastrophic error; the process abends, and RDF stops.
Recovery
See the description of the ALLOCATESEGMENT procedure in the Guardian Procedure Calls
Reference Manual to determine the cause of the failure. Once the underlying cause is corrected,
you can restart RDF.
789
CHECKALLOCATESEGMENT failed with error error
error
is the error number that identifies the specific error.
Cause
The primary process of an RDF process pair received an error from the
CHECKALLOCATESEGMENT system procedure.
Effect
This error is not fatal; processing continues. The backup process is stopped and then re-created
later.
Recovery
See the description of the CHECKALLOCATESEGMENT procedure in the Guardian Procedure
Errors and Messages Manual to determine the cause of the failure. Some corrective action might
be required for the backup process to be re-created without repeated failures. The most likely
cause is insufficient space available for swapping on the swap volume.
790
Backup process created in processor cpu
cpu
is the CPU in which the backup process was created.
Cause
The backup process of a process pair was created in the specified processor.
372 Messages