RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

798
Image trail file open error error on filename
error
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause
An RDF process encountered the specified file-system error while attempting to open the specified
file.
Effect
The process abends, and RDF stops. The exception to this is an error 12 (file in use) issued when
either the receiver or purger attempts to open the file. In this case, the process posts a short delay
and then retries the operation, and it repeats these two steps until successful.
Recovery
For an error 12 associated with an image file, perform a FUP LISTOPENS on the file to determine
which process currently has the designated file open. If the process that has the image file open
is not an RDF process, then stop that process.
In all other cases, restart RDF.
799
Image trail file read error error on filename, RBA rba
error
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
rba
is the relative byte address where the error occurred.
Cause
An RDF process encountered an error while attempting to read an image file.
Effect
This is a catastrophic error; the process abends, and RDF stops.
The message includes the error number returned by the READ system procedure, followed by
the file name.
Recovery
Restart RDF. If the condition persists, you might have to reinitialize RDF.
Preserve the designated image file and report the problem to your service provider.
800
Image trail file write error error on filename
error
is the file-system error number that identifies the specific error.
filename
is the name of the image file associated with the error.
Cause
The receiver process encountered a file-system error while attempting to write to the specified
file.
374 Messages