RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

an updater restart, file-system errors 10, 11, and 71 are not reported by the updater because
they probably represent database operations that have already been performed.
Recovery
Perform any corrective actions suggested by the preceding messages (actions such as reloading
the appropriate CPU, correcting the underlying file error condition).
838
RDFNET process has terminated unexpectedly
Cause
The RDFNET process has terminated unexpectedly.
Effect
This message is issued by the RDF monitor. The monitor sends an abort request to all remaining
RDF processes to stop RDF.
Recovery
Determine the reason why the RDFNET process stopped, correct that problem, then restart RDF.
If the problem persists, contact your service provider.
839
Error - Audit-trail file is missing. File filename
filename
is the name of the audit trail file that could not be found.
Cause
The extractor was unable to find the designated audit trail file.
Usually this occurs because TMF has purged the audit trail file while RDF was stopped. When
RDF is running, RDF prevents TMF from purging audit trail files until the extractor has read them,
even if the extractor is running far behind TMF (the extractor has a large RTD value) and TMF
has performed several rollovers. Use the STATUS RDF command to see the extractor’s current
RTD value.
Effect
The extractor tries to open the audit trail file indefinitely unless an irrecoverable error occurs on
the file.
Recovery
Restore the audit trail file from tape by using SNOOP RESTOREAUDIT.
If copies of the audit trail have not been maintained, then you will have to reinitialize RDF, and
resynchronize the primary and backup databases.
840
Error - Process name is in use, procname
procname
is the name of the process that is in use.
Cause
A user-specified process name is already in use when the monitor tries to start the indicated
process.
Effect
The monitor shuts down RDF in an orderly manner.
Recovery
If you can stop the process and give it another name, you can then simply restart RDF; otherwise,
you will have to alter the name of the RDF process so that the name does not conflict with other
process names.
RDF Messages 385