RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

841
Error - Unable to complete STOP UPDATE. Error error
error
is a file-system error number.
Cause
The monitor was unable to send a shutdown message to an updater because of the indicated
file-system error.
Effect
The monitor terminates the attempt to send STOP UPDATE messages to any other updaters. It
then sends an ABORT RDF message to all the other RDF processes and waits for them to stop.
Recovery
If any updaters have not shutdown after the monitor has sent ABORT RDF messages, then you
might have to terminate the surviving updaters manually using a TACL STOP command.
842
Error - START prevented by RDF TAKEOVER
Cause
You issued a START RDF command, but the monitor detected that RDF has already processed a
TAKEOVER command.
Effect
The START RDF command fails.
Recovery
The backup database is consistent and ready for use as a backup contingency database. Perform
the rest of your installation-specific operations for switching to the backup node (for example,
reroute your communications and start your applications).
If you performed the TAKEOVER operation inadvertently, you will need to issue an INITIALIZE
RDF command and resynchronize the databases.
843
Incorrect version of audit received
Cause
The receiver has received audit from the extractor that does not match the version of audit that
the receiver expects.
Effect
The receiver abends.
Recovery
This is an internal error. Contact your service provider.
844
Phase one database synchronization complete
Cause
The updater that generated this message has completed phase one of the online synchronization
operation for its volume on the backup system.
Effect
The updater starts phase two of the online synchronization operation.
Recovery
This is an informational message; no recovery is required.
386 Messages