RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
The named RDF process' current transaction has been aborted by TMF and the disk process.
Effect
The process restarts.
Recovery
This is an informational message. You must examine the event log to determine why the process
is restarting and if any recovery action is required.
883
Physical volumes in pool exceed the limit of 15
Cause
The updater is configured to a virtual SMF disk that consists of more than 15 physical disks. This
configuration is not supported by the RDF product.
Effect
The updater abends and the RDF subsystem shuts down.
Recovery
Reset your RDF configuration and/or your SMF configuration so that the updaters are either
assigned to physical volumes, or your SMF virtual disks map to 15 or fewer physical volumes.
884
The RDFNET process is restarting
Cause
The RDFNET process encountered a condition that caused it to restart.
Effect
The process restarts and resumes normal processing.
Recovery
Examine the preceding events for this process to try to determine why the process is restarting.
Take corrective action if necessary.
885
Updater phase one takeover processing complete
Cause
The updater has completed the local undo processing phase.
Effect
The updater is ready to commence the next phase of undo processing.
Recovery
This is an informational message; no recovery is required.
886
Updater phase three takeover processing complete
Cause
The updater has reached the end of network undo takeover processing for an RDF network
environment.
Effect
The updater is ready to complete takeover processing.
Recovery
This is an informational message; no recovery is required.
396 Messages