RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Recovery
If this happens during a takeover operation, reissue the TAKEOVER command. When the updater
restarts the table will automatically be resized to accommodate the required number of
transactions. If this happens in a stop-update-to-time operation, restart RDF and issue a new
STOP UPDATE, TIMESTAMP command at a time when there are fewer transactions active.
900
Extractor has finished ZLT processing
Cause
The extractor has sent all remaining audit from the remote mirror(s) on the ZLT standby system
to the backup system.
Effect
The extractor shuts down.
Recovery
This is an informational message; no recovery is required.
901
Extractor is started for ZLT processing
Cause
The extractor is started on the ZLT standby system for ZLT processing.
Effect
The extractor reads and sends all remaining audit from the remote mirror(s) connected to the
ZLT standby system to the receiver on the backup system.
Recovery
This is an informational message; no recovery is required.
902
The remote mirror for volume is missing
volume
is a volume name.
Cause
The extractor has determined that the specified remote mirror is not connected to the ZLT standby
system or that an expected audit trail file is missing.
Effect
The extractor abends.
Recovery
Connect all required remote mirrors to the ZLT standby system and then re-issue the RDF
TAKEOVER command. If you have already connected all remote mirrors and you get this event,
then you already have all audit needed for the takeover operation. To allow the takeover
operation to complete, disable the REMOTE MIRROR attribute in your RDF configuration with
this RDFCOM command: ALTER RDF REMOTE MIRROR OFF. Then re-issue the RDF TAKEOVER
command.
903
Receiver has finished ZLT processing
Cause
All remaining audit from the ZLT standby system has been received and stored in the image
trails for this receiver.
400 Messages