RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

device or file through the OUT command, issued during an RDFCOM session or the OUT parameter
entered in the RDFCOM command that begins the session. The messages appear in alphabetic
order by message text.
$ character detected in the mapping string mapping-string in the MAPFILE
filename
mapping-string
is the erroneous mapping string specified in the mapfile.
filename
is the name of the updater mapfile specified in the updater configuration.
Cause
RDFCOM detected a $ character in the mapping string specified in the updater mapfile when
an ADD VOLUME, ALTER VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION
command was being executed.
Effect
The command fails.
Recovery
Correct the mapping string by removing the $ character, then reenter the command.
Allocation error error# on IMAGETRAIL volume-name
error#
is the file-system error number that identifies the specific error.
volume-name
is the image trail volume on which insufficient storage exists.
Cause
During execution of a START RDF command or a VALIDATE CONFIGURATION command,
RDFCOM determined that sufficient disk storage for image files did not exist in each secondary
image trail for at least one additional image file. As one of its validation checks during processing
of these commands, RDFCOM tries to create a temporary image file on the IMAGETRAIL volume
and then attempts to allocate all extents for it. This allocation failed for the reason indicated by
the file-system number error#.
Effect
The command fails.
Recovery
See the Guardian Procedure Errors and Messages Manual for a description of and recovery
actions for the file-system error. Correct the error indicated by error#. This might necessitate
altering the IMAGETRAIL configuration parameter to specify a new volume for the secondary
image trail. Then, reenter the START RDF or VALIDATE command.
ALTER Failed: error#
error#
is the file-system error number that identifies the specific error.
Cause
An ALTER command failed.
Effect
The ALTER operation was not completed.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
408 Messages