RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
The RDF configuration file is invalid.
Effect
The VALIDATE CONFIGURATION or START RDF command that checked the configuration file
fails.
Recovery
Check and correct the configuration file. Then reenter the VALIDATE CONFIGURATION or START
RDF command.
Couldn't create or clear the BACKUPSYSTEM CONTEXT (error#)
error#
is the file-system error number that identifies the specific error.
Cause
The context file data could not be created or cleared while START RDF processing was being
performed after the INITIALIZE RDF command.
Effect
START RDF processing is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
Couldn't create or clear the PRIMARYSYSTEM CONFIG (error#)
error#
is the file-system error number that identifies the specific error.
Cause
The configuration file data cannot be created or cleared while START RDF processing is performed
after INITIALIZE RDF.
Effect
START RDF processing is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
Couldn't create or clear the PRIMARYSYSTEM CONTEXT (error#)
error#
is the file-system error number that identifies the specific error.
Cause
The context file data cannot be created or cleared while START RDF processing is performed
after INITIALIZE RDF.
Effect
START RDF processing is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
RDFCOM Messages 413