RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Couldn't OPEN the started process: error#
error#
is the error number that identifies the specific error.
Cause
An open error occurred during START RDF or STOP RDF command processing.
Effect
The START RDF or STOP RDF operation is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
Couldn't WRITE startup to the started process error#
error#
is the error number that identifies the specific error.
Cause
A write error occurred during START RDF or STOP RDF command processing.
Effect
The operation is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
cpu:cpu CPUS are NOT available
cpu:cpu
are the primary and backup CPUs, respectively.
Cause
Both the configured primary and backup CPUs were unavailable when a START RDF command
was issued.
Effect
The command fails.
Recovery
Wait until both CPUs become available, and reenter the START RDF command. If necessary,
see your system manager.
cpu:cpu CPUS are not SYSGEN’d
cpu:cpu
are the primary and backup CPUs, respectively.
Cause
A START RDF command failed because the specified CPUs do not exist (they were not configured
during SYSGEN).
Effect
The command fails.
Recovery
Reconfigure RDF to use other CPUs or, if you must use the specified CPUs, see your system
manager.
414 Messages