RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Recovery
Check the control subvolume name and make sure that you are spelling it correctly. Then reenter
the command, including the proper control subvolume name or specifying a different control
subvolume.
Expecting: RDF, MONITOR, EXTRACTOR, RECEIVER, VOLUME
Cause
RDF did not understand the command.
Effect
The command fails.
Recovery
Check the syntax rules for the command you entered. Perhaps you misspelled a keyword
parameter or misplaced a delimiter.
Expecting 'Yes' or 'No' response.
Cause
You have entered an unexpected response to an RDFCOM prompt that requires only either YES
(or Y) or NO (or N) as verification to proceed with your request.
Effect
The requested operation does not take place.
Recovery
Reenter your request, this time specifying either YES, Y, NO, or N to the prompt.
Expecting 'Yes' or 'No' response. Search stopped
Cause
While attempting to initialize RDF to a TMF shutdown timestamp, you have entered an unexpected
response to the RDFCOM prompt that asks if you want RDFCOM to trigger the restoration of an
audit trail file that has been dumped.
Effect
The search for the shutdown timestamp ceases, and the RDF initialization fails.
Recovery
Reenter the INITIALIZE RDF command, to begin the sequence of prompts again. This time, respond
properly (either YES, Y, NO, or N) to the prompt about restoring the audit trail file.
Extended Data Segment Error: error
error
is the NEWPROCESS error number that identifies the specific error.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The START RDF or TAKEOVER operation is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
Extended Swap File Segment Error: error#
error#
is the NEWPROCESS error number that identifies the specific error.
422 Messages