RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The START RDF or TAKEOVER operation is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
EXTRACTOR record exists, use ALTER EXTRACTOR
Cause
An ADD EXTRACTOR command was issued when the configuration file already contained an
extractor record.
Effect
The command fails.
Recovery
No recovery is required if you want to use the existing extractor process as configured. If you
want to change any of the extractor’s configuration options, however, enter an ALTER EXTRACTOR
command that specifies those changes.
EXTRACTOR record NOT found
Cause
The INFO command could not find an extractor record in the configuration file.
Effect
The command fails.
Recovery
Alter the configuration to include an extractor process.
FASTUPDATEMODE is not turned ON for Master Receiver.
Cause
You have turned FASTUPDATEMODE ON for an Auxillary Receiver when the FASTUPDATEMODE
is OFF for the Master Receiver.
Effect
The command fails.
Recovery
Set FASTUPDATEMODE ON for the Master Receiver before setting FASTUPDATEMODE ON for
any Auxiliary Receiver.
FASTUPDATEMODE should be turned OFF for all the Auxilliary Receivers
before it is turned OFF for the Master Receiver.
Cause
You have tried to turn FASTUPDATEMODE OFF for the Master Receiver when FASTUPDATEMODE
is ON for one or more Auxilliary Receivers.
Effect
FASTUPDATEMODE will not be turned OFF for the Master Receiver.
Recovery
Check the FASTUPDATEMODE of all the auxilliary receivers and set it to OFF for all those which
have FASTUPDATEMODE ON before reissuing the command.
RDFCOM Messages 423