RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Recovery
There might be no recovery for this problem. You must perform the database synchronization
without the help of RDFCOM.
IMAGETRAIL for IMAGEVOLUME vol-name does not exist
vol-name
is the image trail volume for which the image trail does not exist.
Cause
You tried to add an updater, but have not yet added an image trail for the updater’s volume.
Effect
The ADD command fails.
Recovery
Add the image trail. Then add the updater.
IMAGETRAIL for IMAGEVOLUME vol-name does not exist or the atindex of
the IMAGEVOLUME does not match the updater’s atindex
vol-name
is the image trail volume
Cause
You tried to add an updater for a particular ATINDEX, but there is no imagetrail configuration
for that value. Either you have not yet added the imagetrail or you added it with a different
ATINDEX.
Effect
The ADD command fails.
Recovery
Review and revise your RDF configuration.
IMAGETRAIL is already in use by Receiver
Cause
You tried to add a secondary image trail, but the volume you specified for that trail is already
being used for receiver’s RDFVOLUME.
Effect
The command fails.
Recovery
Select a different volume for the secondary image trail.
Imagetrails cannot be added if RDF has been started after initialization
Cause
You tried to add a secondary image trail after RDF has been started. However, you can only
add secondary image trails after RDF has been initialized and before it has been started for the
first time following this initialization.
Effect
The command fails.
Recovery
If you must add an image trail, you must stop TMF, allow RDF to catch up to the shutdown, and
then reinitialize and reconfigure RDF.
IMAGETRAIL volume-name has already been added
volume-name
is the name of the volume you specified for the image trail.
426 Messages