RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
You tried to add a secondary image trail on the volume volume-name, but an image trail has
already been added for this volume.
Effect
The command fails.
Recovery
Select a different volume for the secondary image trail.
IMAGETRAIL volume-name is not used by any updater
volume-name
is the name of the image trail.
Cause
While validating your configuration, RDFCOM determined that the image trail on the volume
volume-name is not referenced by any updater processes.
Effect
The validation operation aborts.
Recovery
Delete this image trail
IMAGETRAIL volume-name record not found; DELETE aborted
volume-name
is the name of the secondary image trail that was specified in the command.
Cause
You tried to delete a secondary image trail that does not exist.
Effect
The command fails.
Recovery
Select a different secondary image trail to delete, or select another command.
IMAGETRAIL VOLUME volume-name does NOT exist
volume-name
is the name of the volume.
Cause
While validating your configuration, RDFCOM determined that the volume for this image trail
does not exist on the backup node.
Effect
The validation operation aborts.
Recovery
Delete this image trail volume and all updaters that use it.
IMAGETRAIL VOLUME volume-name is not a disk volume
volume-name
is the name of the volume.
Cause
While validating your configuration, RDFCOM determined that volume-name does not refer
to a disk device on the backup node.
Effect
The validation operation aborts.
RDFCOM Messages 427