RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
You added a receiver with the specified ATINDEX, but there is no extractor with that value.
Effect
The validation fails.
Recovery
Add an extractor with the same ATINDEX value or delete the particular receiver.
No RECEIVER is configured for ATINDEX atindex
Cause
You added an extractor with the specified ATINDEX, but there is no receiver with that value.
Effect
The validation fails.
Recovery
Add a receiver with the same ATINDEX value or delete the particular extractor.
Not able to open the MAPFILE filename, error error#
filename
is the name of the updater mapfile specified in the updater configuration.
error#
is the file-system error number that identifies the specific error.
Cause
RDFCOM was not able to open the updater mapfile when an ADD VOLUME, ALTER VOLUME,
START RDF, START UPDATE, or VALIDATE CONFIGURATION command was being executed.
Effect
The command fails.
Recovery
See the Guardian Procedure Errors and Messages Manual for a description and recovery actions
for the file-system error. Correct the error indicated by error#, then, reenter the command.
No image files could be found in the imagetrail on
volume-name.subvolume-name
volume-name
is the name of the image trail’s volume
subvolume-name
is the name of the image trail’s subvolume.
Cause
The COPYAUDIT command could not find any image files on the remote image trail. This problem
indicates that the receiver’s RETAINCOUNT value was probably not set high enough and that,
as a result, some image files on the remote system were purged.
Effect
The COPYAUDIT command aborts.
Recovery
There is no recovery action. The COPYAUDIT command cannot be executed because image
files needed for this command were already purged from the remote system.
No MONITOR is Configured
Cause
The RDF configuration file is invalid.
RDFCOM Messages 435