RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Operation must be performed on the PRIMARYSYSTEM \primary or BACKUPSYSTEM
\backup
primary
is the name of the primary node that can perform the operation.
backup
is the name of the backup node that can perform the operation.
Cause
The command was issued at a third system, which is not allowed.
Effect
The command fails.
Recovery
Enter another command, or reenter this command at the specific primary or backup node reflected
by this message.
Please wait while RDF searches for the specified shutdown timestamp
Cause
You entered an INITIALIZE RDF command that attempted to initialize RDF at a specific TMF
shutdown timestamp, and responded YES or Y to the subsequent confirmation prompt, directing
the subsystem to proceed with the initialization.
Effect
RDFCOM reads backward through the MAT in search of a TMF shutdown record with the same
timestamp you specified.
Recovery
This is an informational message; no recovery is required. You can terminate the operation at
any time by pressing the BREAK (or equivalent) key.
PNETTXVOLUME volume for ctrl-subvol must be protected by a MAT
based-updater
volume
is the name of an RDF data volume.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause
The specified volume for the RDF subsystem with the specified control subvolume is not configured
to the Master Audit Trail (MAT).
Effect
Validation fails.
Recovery
The PNETTXVOLUME must be configured to the Master Audit Trail (MAT). You need to reconfigure
your network master and the subsystem with the specified control subvolume.
PNETTXVOLUME volume is not configured to a MAT based updater
volume
is the name of an RDF data volume.
Cause
The specified PNETTXVOLUME is not configured to a MAT based updater.
Effect
Validation fails.
RDFCOM Messages 439