RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

error#
is the file-system error number that identifies the specific error.
Cause
The COPYAUDIT command encountered the specified error while attempting to position into a
remote image file on the remote image trail.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
Position error error# on report file filename.
error#
is the file-system error number that identifies the specific error.
filename
is the name of the file name you specified for generating the report.
Cause
When a VALIDATE CONFIGURATION command is executed, when writing in to the user specified
report file, RDFCOM determined that positioning to the EOF failed.
Effect
The Report generation fails.
Recovery
See the Guardian Procedure Errors and Messages Manual for a description of the recovery
actions for the file-system error. Correct the error indicated by error#, then reenter the command.
Primary node in network master record is incorrect primary-system
primary-system
is an RDF system name.
Cause
The network master network record does not have the specified primary system name.
Effect
Validation fails.
Recovery
You must reconfigure your network master.
PRIMARYSYSTEM (\node) and BACKUPSYSTEM (\node) are the same
node
is the name assigned to both the primary and backup nodes.
Cause
The RDF configuration file is invalid: both primary and backup node names are identical.
Effect
The validation fails.
Recovery
Alter the RDF configuration to reflect different names for these two nodes.
Process Name Error: error#
RDFCOM Messages 441