RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The START RDF or TAKEOVER operation is aborted.
Recovery
Change the library filename.
Program File Error: error# on progfile
error#
is the error number that identifies the specific error.
progfile
is the name of the program file on which the error was encountered.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The START RDF or TAKEOVER operation is aborted.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
RDF already in TAKEOVER processing
Cause
The operator issued a TAKEOVER command at the backup node while RDF was performing a
TAKEOVER operation.
Effect
The last TAKEOVER command is ignored.
Recovery
This is an informational message; no recovery is required.
RDF configuration file is not open, use OPEN command
Cause
The configuration file must be open before any RDFCOM commands other than OPEN or OBEY
can be executed.
Effect
The attempted operation is aborted.
Recovery
Open the configuration file with the OPEN command.
RDF has not been initialized.
Cause
You issued an INITIALIZE RDF command, but entered NO or N in response to the subsequent
confirmation prompt for continuing the initialization process.
Effect
RDF is not initialized.
Recovery
This is an informational message; no recovery is required.
RDFCOM Messages 443