RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Recovery
Alter the configuration to include all RDF global parameters.
RDF Shutdown in progress, please wait...
Cause
RDF is shutting down.
Effect
The shutdown operation continues.
Recovery
This is an informational message; no recovery is required.
RDF START Failure, Scan LOGFILE for reason
Cause
A START RDF command failed. RDF writes a description of the problem in the LOGFILE.
Effect
The START RDF command fails.
Recovery
Check the EMS event log for the message covering this error. If possible, correct the cause of
the error and reissue the START RDF command. Otherwise, contact your system manager.
RDF subsystem ctrl-subvol is not configured as a Network master
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause
The RDF subsystem that you specified as your network master has not been configured as a
network master.
Effect
Validation fails.
Recovery
You need to reconfigure your local subsystem and specify the control subvolume of your network
master. You might also need to reconfigure your network master.
RDF subsystem ctrl-subvol stopped. TMF audit trails remain pinned.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause
The user issued a STOP RDF command for the RDF subsystem with the specified control subvolume.
Effect
The RDF product has stopped, but the TMF product continues to pin audit trail files on behalf of
the RDF product.
Recovery
If you intend to restart the RDF product, no recovery action is necessary.
If you intend to delete the RDF configuration, then you must issue an RDFCOM UNPINAUDIT
command. Failure to do this could cause TMF to run out of audit trail space.
RDFCOM internal error in handling prompt
Cause
RDFCOM detected an internal error in handling your response to the RDFCOM prompt.
RDFCOM Messages 445