RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Effect
The attempted command is aborted.
Recovery
Contact the Global Mission Critical Solution Center (GMCSC) or your service provider.
RDFCOM is asking the TMP to restore the file. If the file was previously
dumped to tape, watch for the TMP to tell you to mount the appropriate
tape.
Cause
In response to a prompt, you requested RDFCOM to trigger restoration of an audit trail file. If
the file has been previously dumped to tape, you must now watch the EMS log for the TMP’s
prompt to mount the appropriate tape.
Effect
The restore operation proceeds.
Recovery
When the tape-mount prompt appears in the EMS log, mount the tape.
RDFNETS process only allowed for RDF network master configuration.
Cause
You have attempted to add the NetSynch process to your configuration, but your configuration
is not the network master.
Effect
The configuration command fails.
Recovery
Do not add this record.
RDFVOLUME in network master record is incorrect rdf-vol.
rdf-vol
is the RDFVOLUME specified in the network record of the network master.
Cause
The RDFVOLUME of the current RDF configuration does not match the value specified in the
network record of the network master.
Effect
Validation fails.
Recovery
You must reconfigure your network master and possibly your local configuration.
RDFVOLUME in network master record is invalid.
Cause
The RDFVOLUME of the current RDF configuration is invalid in the network record of the network
master.
Effect
Validation fails.
Recovery
You must reconfigure your network master and possibly your local configuration.
RDFVOLUME is not allowed for an aux receiver. Auxiliary receivers do
not have an RDFVOLUME.
Cause
You tried to add an auxiliary receiver for which you had specified an RDFVOLUME.
446 Messages