RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Effect
The ADD command fails.
Recovery
Issue a RESET RECEIVER command, and then reconfigure the particular receiver without specifying
an RDFVOLUME.
Read error error# on file remote-config-file
error#
is the file-system error number that identifies the specific error.
remote-config-file
is the name of the remote configuration file.
Cause
The COPYAUDIT command encountered the specified error while attempting to read the remote
configuration file.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
Read error error# on remote image file
error#
is the file-system error number that identifies the specific error.
Cause
The COPYAUDIT command encountered the specified error while attempting to read data from
a remote image file on the remote image trail.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT command.
Otherwise, see your service provider.
Read error error# on remote ZFILEINC file
error#
is the file-system error number that identifies the specific error.
Cause
The COPYAUDIT command encountered the specified error while attempting to read data from
the remote ZFILEINC file.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT command.
Otherwise, contact your service provider.
RECEIVER RDFVOL error error# on allocation
RDFCOM Messages 447