RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Recovery
Specify a valid disk volume.
RECEIVER RDFVOLUME volume-name does NOT exist
volume-name
is the name of the nonexistent RDFVOLUME file.
Cause
The RDF configuration file is invalid.
Effect
The validation of the receiver fails.
Recovery
Specify a valid disk volume.
RECEIVER Record does not exist
Cause
You tried to add a secondary image trail before adding the receiver’s configuration record.
Effect
The command fails.
Recovery
Add the receiver’s record. Then, add the secondary image trail.
RECEIVER record exists, use ALTER RECEIVER
Cause
An ADD RECEIVER command was issued when the configuration file already contained a receiver
record.
Effect
The command fails.
Recovery
No recovery is required if you want to use the existing receiver process as it is configured. If
you want to change any of the receiver’s configuration options, however, enter an ALTER
RECEIVER command that specifies those changes.
RECEIVER record NOT found.
Cause
The INFO command could not find a receiver record in the configuration file.
Effect
The command fails.
Recovery
Alter the configuration to include a receiver process.
Receiver record not found for subsystem ctrl-subvol.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause
RDFCOM was unable to read the receiver record for the RDF subsystem with the specified control
subvolume.
Effect
Validation fails.
RDFCOM Messages 449