RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
RDFCOM could not find the updater mapfile when an ADD VOLUME, ALTER VOLUME, START
RDF, START UPDATE, or VALIDATE CONFIGURATION command was being executed.
Effect
The command fails.
Recovery
Provide an existing mapfile and reenter the command.
The MAPFILE filename should be an edit file
filename
is the name of the updater mapfile specified in the updater configuration.
Cause
RDFCOM found that the updater mapfile is not an EDIT format file when an ADD VOLUME,
ALTER VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION command was
being executed.
Effect
The command fails.
Recovery
Provide an edit file and reenter the command.
The MAPLOG file filename could not be created: error error#
filename
is the name of the updater maplog specified in the updater configuration.
error#
is the file-system error number that identifies the specific error.
Cause
Create operation returned an error when RDFCOM tried to create the updater maplog file when
an ADD VOLUME, ALTER VOLUME, START UPDATE, or START RDF command was being executed.
Effect
The command fails.
Recovery
See the Guardian Procedure Errors and Messages Manual for a description of the recovery
actions for the file-system error. Correct the error indicated by error#, then reenter the command.
The MAPLOG file filename should be an edit file
filename
is the name of the updater maplog specified in the updater configuration.
Cause
RDFCOM found that the updater maplog is not an edit format file when an ADD VOLUME, ALTER
VOLUME, START RDF, or START UPDATE command was being executed.
Effect
The command fails.
Recovery
Provide an edit file and reenter the command.
The MAT file with sequence number seq-num is not currently on disk.
RDFCOM can trigger the restoration of the file, but only as a waited
operation and you must mount the tapes Do you want RDFCOM to restore
the file?
458 Messages