RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Effect
The COPYAUDITcommand aborts.
Recovery
Correct the REMOTESYS remote-sys and REMOTECONTROLSUBVOL rcvs parameters and
reissue the COPYAUDIT command.
RDFNET must be a named process
Cause
You must specify a process name for the RDFNET process before issuing an ADD command.
Effect
The start command fails.
Recovery
You must reconfigure RDF with a named RDFNET process.
"The remote control subvolume\bksys.$SYSTEM.subvol is not empty. The
files on the remote control subvolume must be purged. Please note, these
files might belong to another RDF configuration.
\bksys
is the name of the RDF backup system.
subvol
is the name of the remote control subvolume.
Cause
You tried to execute an INITIALIZE RDF command, but the RDF control files (such as CONFIG
or CONTEXT) already exist on the remote control subvolume. If these files are on the backup
system, then that name is specified.
Effect
The INITIALIZE RDF command aborts.
Recovery
You must purge \$SYSTEM.subvol.* on the backup systems before you can retry the INITIALIZE
RDF command. Before doing so, however, be sure that the existing files do not belong to a
different RDF configuration that is still valid.
The specified timestamp cannot be in the future
Cause
You have specified an INITTIME timestamp that is in the future rather than in the past.
Effect
The INITIALIZE RDF command aborts.
Recovery
Reissue the STOP UPDATE, TIMESTAMP command, specifying a timestamp that is earlier than
the current system time as shown in the status display.
The specified timestamp must be at least five minutes greater than the
current time
Cause
The timestamp specified in a STOP UPDATE, TIMESTAMP command is less than five minutes
from the current time.
Effect
The STOP UPDATE command aborts.
460 Messages