RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Effect
The requested RDFCOM operation fails.
Recovery
Configure and start TMF, and request the RDFCOM operation again.
TMF is not running.
Cause
While either attempting to validate the RDF configuration or to start RDF, RDFCOM discovered
that TMF is not running.
Effect
The command fails.
Recovery
Start TMF. Then validate your configuration and start RDF.
TMF is not started yet.
Cause
TMF has not been started.
Effect
The requested RDFCOM operation fails.
Recovery
Check the contents of the RDF configuration file, issue a VALIDATE RDF command to verify the
configuration, and reissue your request for the RDFCOM operation you originally wanted to
perform.
TMF NAT table is full.
Cause
There is a problem with TMF.
Effect
The configuration validation fails.
Recovery
Check the status of TMF. When TMF is operational, reenter the command.
TMF Shutdown at timestamp has been found. RDF starts with MAT file
filename at RBA relative-byte-address
timestamp
is the shutdown timestamp sought.
filename
is the name of the MAT file that contained the record with the matching timestamp.
relative-byte-address
is the relative byte address where the record with the matching timestamp was found in the
MAT file.
Cause
RDFCOM has found the TMF shutdown timestamp identical to the timestamp specified in the
INITIALIZE RDF timestamp command.
Effect
RDF is ready to be initialized at the specified timestamp.
Recovery
This is an informational message; no recovery is required.
RDFCOM Messages 463