RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

TMF STOP in progress.
Cause
A TMF stop operation is in progress.
Effect
TMF stops, and RDF automatically stops thereafter.
Recovery
This is an informational message; no recovery is required.
To issue this command, the RTD time of the extractor must be 0:00. Have
you confirmed that the RTD is 0:00?
Cause
You are attempting to execute an RDFCOM STOP SYNCH command. To ensure that the extractor
does not miss any audit record, the extractor RTD must be 0:00 before executing this command.
Effect
You are prompted for a “yes” or “no” response.
Recovery
Enter YES (or Y) to execute the command or NO (or N) to cancel it.
Too many volumes are configured (number > max)
max
is 64 for RDF, and 255 for the RDF/MP, MPX, IMP, or IMPX
Cause
The maximum number of volumes that can be protected on a node (64 for RDF, 255 for RDF/MP,
MPX, IMP, or IMPX) has been exceeded.
Effect
The configuration validation fails.
Recovery
Delete some of the volumes.
Too many volumes are specified in this ALTER command
Cause
You specified too many volumes in the command parameter list of an ALTER command.
Effect
The ALTER command aborts.
Recovery
Eliminate some of the volumes from the command parameter list.
Triple Contingency CopyAudit command aborted.
Cause
The COPYAUDIT command has aborted because of a problem reported in the previous RDFCOM
message.
Effect
The COPYAUDIT command aborts.
Recovery
Correct the problem reported in the previous error message and reissue the COPYAUDIT
command.
Unable to allocate Map
464 Messages