RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The NEWPROCESS procedure fails.
Recovery
Make sufficient space available on the swap volume for the requested operation.
Unable to communicate with CPU cpu
cpu
is the CPU that is not responding.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The NEWPROCESS procedure fails.
Recovery
Check the status of the CPU, or enter SET and ALTER commands to direct the process to run on
a different CPU.
Unable to get MAT filename with sequence number seq-num from the TMP;
search stopped.
seq-num
is the sequence number of the MAT file.
Cause
RDFCOM could not obtain the fully qualified name of the audit trail file with the specified
sequence number from the TMP.
Effect
RDFCOM terminates the search for a TMF shutdown timestamp and then its attempt to initialize
RDF.
Recovery
Check to see if TMF is started:
• If it is not, start TMF before you again attempt to initialize RDF.
• If it is running and this error occurs, this is an internal error. Contact the Global Mission
Critical Solution Center (GMCSC) or your service provider.
Unable to obtain the process access id of RDFCOM
Cause
RDFCOM could not obtain the process access id of the user who started the RDFCOM session.
Effect
The ADD command fails.
Recovery
Exit RDFCOM and then try again. If the problem persists, contact the Global Mission Critical
Solution Center (GMCSC) or your service provider.
Unable to purge old image file due to error error# DELETE ABORTED
error#
is the file-system error number that identifies the specific error.
Cause
A START RDF command failed because the reported error prevented RDFCOM from purging the
old image file.
RDFCOM Messages 465