RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

UPDATE is already off
Cause
A STOP UPDATE command was issued when updating is disabled.
Effect
The command fails.
Recovery
This is an informational message; no recovery is required.
UPDATE is already on
Cause
A START UPDATE command was issued when updating is enabled.
Effect
The command fails.
Recovery
This is an informational message; no recovery is required.
UPDATE request could not be performed
Cause
RDFCOM could not execute a START UPDATE or STOP UPDATE command.
Effect
The command fails.
Recovery
Scan the EMS event log to determine why the command could not be performed. Correct the
error condition, if possible, and request the update operation again.
VOLUME device is NOT a disk volume
device
is the non-disk device assigned to the updater.
Cause
The RDF configuration file is invalid.
Effect
RDF will not start.
Recovery
Change the RDF configuration to reflect a valid disk volume.
VOLUME device UPDATEVOLUME is NOT a disk volume
device
is the non-disk device assigned for the UPDATEVOLUME.
Cause
The RDF configuration file is invalid.
Effect
RDF will not start.
Recovery
Change the RDF configuration to reflect a valid disk volume.
VOLUME Record exists, use ALTER VOLUME volume
RDFCOM Messages 467