RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
An ADD VOLUME command was issued when the configuration file already contained an updater
record for the volume.
Effect
The RDF command fails.
Recovery
No recovery is required if you want to use the existing updater process as it is configured. If
you want to change any of the updater’s configuration options, however, enter an ALTER VOLUME
command that specifies those changes.
VOLUME volume contains too many physical volumes The SMF pool cannot
contain more than 15 volumes
volume
is the offending SMF virtual disk
Cause
The updater is configured to a virtual SMF disk that consists of more than 15 physical disks. This
configuration is not supported by the RDF product.
Effect
RDF will not start.
Recovery
Reset your RDF configurations and/or your SMF configuration so that the updaters are either
assigned to physical volumes, or your SMF virtual disks map to 15 or fewer physical volumes.
VOLUME volume does NOT exist
volume
is the volume on the primary node for which the updater is responsible.
Cause
The RDF configuration file is invalid.
Effect
RDF will not start.
Recovery
Bring the volume up or delete it from the RDF configuration.
VOLUME volume is NOT configured within TMF
volume
is the volume on the primary node for which the updater is responsible.
Cause
The RDF configuration file is invalid.
Effect
RDF will not start.
Recovery
Delete the volume from the RDF configuration or add the volume to the TMF configuration.
VOLUME volume needs the IMAGETRAIL image trail; DELETE aborted
volume
is the name of the volume on the primary system that requires the image trail.
image trail
is the name of the required image trail.
468 Messages