RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
REPLICATEPURGE is turned OFF but INCLUDEPURGE or EXCLUDEPURGE lists have been added
for a volume.
Effect
The INCLUDEPURGE or EXCLUDEPURGE lists will be ignored for the volume.
Recovery
SET RDF REPLICATEPURGE to ON before starting RDF.
*** Warning *** Updater Open Mode has been specified the same value as
it was before using the ALTER RDF UPDATEROPEN command.
Cause
The ALTER RDF UPDATEROPEN command has been specified with the same mode which was
present prior to issuing the command.
Effect
The command fails.
Recovery
This is an informational message. No action needed.
Write error error# on attempt to reach the extractor, STOP SYNCH command
aborted.
error#
is the file-system error number that identifies the specific error.
Cause
You are attempting to execute an RDFCOM STOP SYNCH command, but RDFCOM encountered
the specified error while sending the message to the extractor.
Effect
The STOP SYNCH command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. Correct the problem and reissue the STOP SYNCH command.
Write error error# on local image file
error#
is the file-system error number that identifies the specific error.
Cause
The COPYAUDIT command encountered the specified error while attempting to write data to a
local image file on the local image trail.
Effect
The COPYAUDIT command aborts.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the COPYAUDIT command.
Otherwise, see your system manager.
Write error error# on local ZFILEINC file
error#
is the file-system error number that identifies the specific error.
472 Messages