RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
File error: error# trying to read RDFlog file
error#
is the file-system error number that identifies the specific error.
Cause
A file-system error occurred while RDFSCAN was trying to read the current log file
Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting file-system errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
Filename given could not be opened, old file still in use
Cause
A command tried to access a file that was in use.
Effect
The command fails.
Recovery
This is an informational message; no recovery is required.
Filename is an invalid filename
Filename
is the invalid filename.
Cause
The specified file is not a valid file recognized by the operating system.
Effect
The command fails.
Recovery
Check the filename for correct spelling and compliance with syntax rules.
HELP for command not found
command
is the RDFSCAN command for which online help was requested.
Cause
The command for which HELP text was requested is not a valid RDFSCAN command.
Effect
The HELP command fails.
Recovery
Enter another RDFSCAN command, or select another command for which to request help.
RDFSCAN Messages 477