RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

This command uses DOME as the CSV. To use a control subvolume with a suffix, say E, one should
use the command:
MONITOR RDF DOMEE->TANDA
where,
DOMEE is the control subvolume and TANDA is the RDF Backup System without '\'.
Adding and Removing RDF Environments
The RDF SGP performs the auto detection and processing of the RDF environments added through
the MONITOR command when the process starts. If RDF environments are added or removed while
the RDF SGP is running, ASAP does not monitor them until the next time the RDF SGP is stopped
and restarted.
Version Compatibility
The RDF SGP supplied with each version of RDF/IMP(X) only runs with that version of RDF. All
RDF/IMP(X) environments on a given system must match the version of the RDF SGP.
RDF Metrics Reported by ASAP
For each RDF entity, the RDF SGP passes the information shown in Table 18 back to ASAP.
Table 18 RDF Metrics Reported by ASAP
UpdaterRDFNETPurgerImagetrailReceiverExtractorMonitorInformation
Passed to
ASAP
XX
1
XXXXXName
Operational
Status:
XX
1
XXXXX“Running”
X———X——“Error”
XX
1
XXXXX“Stopped”
XX
1
XXXXX“Aborted”
X——————“Updt off”
XX
1
XXXXX“TKOV
complete”
XX
1
XXXXX“TKOV part
complete”
XX
1
XXXXX“TKOV
active”
XX
1
XXXXXError
XX
1
X—XXXPin
X——————Primary
Volume
X——————Backup
Volume
X——XX
2
XXVolume
X——XXX—TMF
Auxiliary
Audit Index
482 Using ASAP