RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Setting Global Attributes
The SET RDF command establishes values for global attributes that apply either to the entire RDF
system or to all updater processes. These attributes and their default values are:
$0
• LOGFILE
10 (seconds)
• UPDATERDELAY
60 (seconds)
• UPDATERTXTIME
60 (seconds)
• UPDATERRTDWARNING
PROTECTED
• UPDATEROPEN
$SYSTEM.RDF
• SOFTWARELOC
OFF
• NETWORK
OFF
• NETWORKMASTER
ON
• UPDATEREXCEPTION
volume undefined
• LOCKSTEPVOL
OFF
• REPLICATEPURGE
OFF
• REMOTE MIRROR
system undefined
• REMOTE STANDBY
(no default)
• OWNER
LOGFILE Attribute
The LOGFILE attribute specifies the name of the EMS collector to which all RDF command, event,
error, and warning messages are to be directed.
The following commands specify the EMS collector $CTD25 as the RDF log file on both the primary
and backup systems:
]SET RDF LOGFILE $CTD25
]ADD RDF
The collector on the primary system receives log messages from the extractor and monitor processes
(plus RDFCOM messages that are logged in message 835).
The collector on the backup system receives log messages from the receiver, purger, and all updater
processes (plus RDFCOM messages that are logged in message 835).
UPDATERDELAY Attribute
The UPDATERDELAY attribute specifies how many seconds (from 1 to 10) the updater processes
should delay upon reaching the logical EOF in the image trail before checking to see if logical
EOF has advanced. The default is 10 seconds.
This attribute should be left at the default value unless you have a very specific reason for lowering
it; lowering the UPDATERDELAY value could adversely impact updater performance.
UPDATERTXTIME Attribute
The UPDATERTXTIME attribute specifies the maximum transaction duration in seconds (from 10 to
300) for all updater processes. The default is 60 seconds.
78 Installing and Configuring RDF