Spooler FASTP Network Print Processes Manual

Installation, Configuration, and Usage
Considerations for FASTPSMB
Spooler FASTP Network Print Processes Manual — 427528-007
4 - 13
Optional DEVICE Attributes for FASTPSMB
POOLKEY = pool-key-value
specifies a 32-bit pool key value that might be required when the TYPE attribute
value is POOL.
A pool key is optionally associated with the POOL object type as part of the SCF
configuration of the POOL object for TLAM. Note that the POOLKEY attribute is
not used with NBT or NBX.
SHADOW[n] = shadow-file-namen...
is a required attribute if tracing is enabled (that is, if bit 1 (%40000) of the PARM
attribute is set using the Spoolcom DEV command). Each value specified defines
the Guardian file name of a Guardian file used for trace output. If a file name is not
fully qualified, the volume and subvolume name default to the volume and
subvolume where the object code for the FASTPSMB print process resides. From
1 to 8 trace files can be defined.
Tracing is discussed in Section
8, Troubleshooting and Using the Trace Facility.
TIMEOUT = interval
specifies the number of seconds a FASTPSMB print process waits before
considering a retryable I/O operation to be a failure. The TIMEOUT specification is
optional. The default value is 0, which causes FASTPSMB to wait indefinitely or
until the I/O process for the device declares the operation a failure.
Table 4-6. Valid and Invalid Null Password Specifications
NET SHARE Command
Password
S
pecification Comments
net share SRV1=LPT1 not specified Valid: the password defaults
to th
e NULL value.
net share SRV1=LPT1 NULL PASSWORD = NULL Valid: the password is
“NULL”.
net share SRV1=LPT1 PASSWORD = NULL Not valid: any attempt to
access th
e LAN is rejected.
net share SRV1=LPT1NULL not specified Not valid: any attempt to
access th
e LAN is rejected.
net share SRV1=LPT1 null PASSWORD = null Valid: the password is “null”.