Spooler FASTP Network Print Processes Manual

Installation, Configuration, and Usage
Considerations for FASTPXNS
Spooler FASTP Network Print Processes Manual — 427528-007
7 - 2
Installation Requirements
Installation Requirements
Before the FASTPXNS print process can be installed and configured, the following
requirements must be met:
•
The Spooler subsystem must be installed and configured on your host system.
•
One of the following set of products must be installed and configured on your host
system to provide LAN services:
°
For D-series systems, the following products must be installed:
°
Tandem LAN Access Method (TLAM)
°
Subsystem Control Process (SCP)
FASTPXNS uses the SPI interface to TLAM to obtain the TLAM Controller
Ethernet address. FASTPXNS assumes the SCP process name is $ZNET.
This can be changed by adding a suitable DEFINE before starting the
Spooler supervisor.
For example:
>ADD DEFINE =SCP , FILE $ZSCP.#ZSPI
Note that the process qualifier #ZSPI is mandatory.
°
For G-series and H-series systems, TLAM is obsolete as well as MLAM and
MLMUX. The Port Access Method (PAM), and ServerNet LAN Systems Access
Method (SLSA) have replaced the D-series TLAM subsystem. Therefore, for
G-series systems, the following products must be installed:
°
Port Access Method (PAM)
°
ServerNet LAN Systems Access (SLSA) subsystem
•
Your LAN must be installed and appropriately connected to your host system.
For additional information about the inst
allation and configuration of TLAM, PAM, and
SLSA, including any LAN requirements, consult the following manuals:
•
TLAM Configuration and Management Manual (for D-series systems only)
•
SCF Reference Manual for TLAM (for D-series system only)
•
LAN Configuration and Management Manual (for G-series systems only)
•
PAM Configuration and Management Manual (for G-series systems only)