Spooler FASTP Network Print Processes Manual

Installation, Configuration, and Usage
Considerations for FASTPXNS
Spooler FASTP Network Print Processes Manual — 427528-007
7 - 8
Spooler Configuration Considerations for
FASTPXNS
Spooler Configuration Considerations for
FASTPXNS
The Spooler configuration tasks required for any FASTP network printer also are
required for the FASTPXNS print process. However, special consideration must be
given to the following aspects of these configuration tasks for the FASTPXNS
configuration:
•
Device name format
•
Some device attributes
For a complete discussion of the Spooler configuration tasks required to configure a
FASTPXNS print process, see Configuring a FASTP Network Print Process in the
Spooler Subsystem on page 2-5.
Device Names
Spooler device names for Xerox printers consist of the I/O process name, the port
name, and an optional device-name qualifier as follows:
where
$lan
is the TLAM or PAM I/O process name.
#port-name
is the port name.
#qualifier
is a optional qualifier that uniquely identifies the printer. If only one printer is
attached to the LAN then this qualifier can be omitted.
For example, two Xerox printers on one LAN might be configured as:
DEV $LAN1.#XEROX.P1 }
DEV $LAN1.#XEROX.P2 }
whereas a single printer on one LAN might be configured as:
DEV $LAN2.#XEROX
$lan.#port-name[.#qualifier]