Spooler FASTP Network Print Processes Manual

EMS Messages
Spooler FASTP Network Print Processes Manual — 427528-007
B - 71
FASTP EMS 512 Text Messages
file-err
is the file-system error returned. See the Guardian Procedure Errors and
Messages Manual for explanations of file-system errors.
supervisor-name
is the name of the Spooler supervisor process.
Cause. The FASTP network print process attempted to send a message to the
Spooler supervisor process to obtain information but was unable to do so for the
reason indicated. For example, the FASTP network print process sends messages to
the Spooler supervisor to obtain details about certain NetBatch jobs, or when jobs are
routed to a Spooler collector process.
Effect. The FASTP network print process attempts to complete printing without this
information.
Recovery. Verify that the Spooler is properly configured and is running. If the error
persists, contact your service provider as described in Troubleshooting and Reporting
Problems on page 8-1.
512
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
Cause. This message applies to FASTP
TCP only. FASTPTCP could not connect to
the remote device after 60 consecutive attempts.
Effect. None; this message is informational only. F
ASTPTCP continues to attempt to
complete a connection.
Recovery. If the message persists, verify the following:
•
The ADDRESS parameter matches the IP address of the remote device.
•
An operational network path to the device exists.
•
The device is online and properly configured.
proc-num DEV: device-name Connection timeout: device offline
or possible network or address problem