Spooler FASTP Network Print Processes Manual

Installing and Configuring FASTP Network Print
Processes
Spooler FASTP Network Print Processes Manual — 427528-007
2 - 3
Installing a FASTP Network Print Process
Table 2-1 lists the FASTP network print processes that are available on both G-series
and D-series systems including the network communications protocols they support,
their product numbers, and their object files.
To install a FASTP network print process, use the Distributed Systems
Management/Software Configuration Manager (DSM/SCM) to copy the FASTP
network print process object file from the Site Update Tape (SUT) to your system. For
more information about using DSM/SCM, refer to the DSM/SCM User’s Guide.
As a result of the installation process, the FASTP network print process object file is
placed in the $SYSTEM.SYSTEM subvolume.
Table 2-1. Object Files for FASTP Network Print Process Products
Network Protocol Product Number Object File Name
TCP/IP LANs T8932 $SYSTEM.SYSTEM.FASTPTCP
SMB LANs T9146 $SYSTEM.SYSTEM.FASTPSMB
NetWare LANs T8924 $SYSTEM.SYSTEM.FASTPNOV
X.25 WANs T8934 $SYSTEM.SYSTEM.FASTPX25
XNS LANs T8931 $SYSTEM.SYSTEM.FASTPXNS
Note. For H- and J-series RVUs, a native mode version of FASTPTCP is distributed in
$SYSTEM.S
YSTEM.FASTPTCN, in addition to $SYSTEM.SYSTEM.FASTPTCP.
Caution. As of the D48.00 RVU, DSM/SCM is the recommended installation tool. For
G-series RVUs, only DSM/SCM can be used.
Note. For FASTPTCP only, in addition to the placement of the FASTPTCP object file in the
$SYSTEM.S
YSTEM subvolume, the SHAP object file is placed in the $dsv.ZTCPPRT
subvolume, and the FASTKCUT object file is placed in the $SYSTEM.SYSTEM subvolume.