Spooler FASTP Network Print Processes Manual

EMS Messages
Spooler FASTP Network Print Processes Manual — 427528-007
B - 131
FASTP EMS 512 Text Messages
512
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
address
if the NUA was set by using the X25NUA attribute in the FASTCNFG file, this field
contains the network address; if the NUA was set by using the DESTADRR
attribute of X25AM, this field contains the text: See X.25 Subdevice Config.
file-err
is the file-system error returned. Typically, the value is 140. See the Guardian
Procedure Errors and Messages Manual for explanations of file-system errors.
Cause. This message applies to FASTPX25 only. FASTPX25 could not establish a call
to the remote printer. This error is only recorded when bit 2 (%20000) of the PARM
attribute of the Spoolcom DEV command is set.
Effect. The supervisor considers error 140 to be a retryable error and directs
FASTPX25 to retry the printing operation at the interval configured by the Spoolcom
DEV RETRY value. As a default, FASTPXNS attempts to reprint the job at the last
known correctly printed page. As a result, FASTPX25 might reprint certain pages.
Recovery. Under normal circumstances, no operator intervention is required.
However, you can modify the supervisor’s response to this error by means of the
RECOVERY attribute in the FASTCNFG file. The default value is NORMAL, which
results in the behavior described above. If you set this attribute to REPRINT,
FASTPX25 returns to the first page of the job when printing is resumed.
proc-num DEV: device-name X25 Call failed to NUA address,
Err:file-err