Spooler FASTP Network Print Processes Manual

EMS Messages
Spooler FASTP Network Print Processes Manual — 427528-007
B - 133
FASTP EMS 512 Text Messages
mmm
is the contents of the diagnostic field in the X.25 clear request packet.
Cause. This message applies to FASTPX25 only. An X.25 clear request packet was
received. This error is only recorded when bit 2 (%20000) of the PARM attribute of the
Spoolcom DEV command is set.
Effect. Clear request packets are translated into error 140 (circuit disconnect) before
the Spooler supervisor is informed of the error. The supervisor considers error 140 to
be a retryable error and directs FASTPX25 to retry the printing operation at the interval
configured by the Spoolcom DEV RETRY value. As a default, FASTPXNS attempts to
reprint the job at the last known correctly printed page. As a result, FASTPX25 might
reprint certain pages.
Recovery. Under normal circumstances, no operator intervention is required.
However, you can modify the supervisor’s response to this error by means of the
RECOVERY attribute in the FASTCNFG file. The default value is NORMAL, which
results in the behavior described above. If you set this attribute to REPRINT,
FASTPX25 returns to the first page of the job when printing is resumed.
512
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
nnn
is the contents of the cause field in the X.25 reset p
acket.
mmm
is the contents of the diagnosis field in the X.25 reset packet.
Cause. This message applies to FASTPX25 only
. A circuit reset (error 122) has
occurred. This message is only recorded when bit 2 (%20000) of the PARM attribute of
the Spoolcom DEV command is set.
Effect. Circuit resets are translated into error 140 (circuit disconnect) before returning
the error to the S
pooler supervisor. The supervisor considers error 140 to be a
retryable error and directs FASTPX25 to retry the printing operation at the interval
configured by the Spoolcom DEV RETRY value. As a default, FASTPXNS attempts to
reprint the job at the last known correctly printed page. As a result, FASTPX25 might
reprint certain pages.
proc-num DEV: device-name X25 Line Reset Cause: nnn, Diag mmm