Spooler FASTP Network Print Processes Manual

EMS Messages
Spooler FASTP Network Print Processes Manual — 427528-007
B - 135
FASTP EMS 512 Text Messages
n
is type of request that was sent. The possible values are 1 (End Request) or 2
(End Reply).
Cause. This message applies to FASTPXNS only. FASTPXNS encountered an
unexpected Level 2 problem when attempting to close the XNS connection.
Effect. Informational only; the connection closes.
Recovery. If the error persists, contact your service provider as described in
Troubleshooting and Reporting Problems on page 8-1.
512
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
Cause. This message applies to FASTPXNS only. FASTPXNS did not receive a
Courier exchange version response. Courier is a protocol used to establish the
environment before printing and after printing.
Effect. This message is only a warning. FASTPXNS attempts to continue setting up
for print job transfer.
Recovery. If the error persists, it could indicate a Xerox software problem. Contact
your service provider as described in Troubleshooting and Reporting Problems on
page 8-1.
512
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
Cause. This message applies to FASTPXNS only
. FASTPXNS did not get a response
to the printing protocol request for job status at the end of job.
Effect. FASTPXNS attempts to close the XNS connection.
proc-num DEV: device-name XNS Exchange Version Failure
proc-num DEV: device-name XNS Get Job Status Failure