Spooler FASTP Network Print Processes Manual

EMS Messages
Spooler FASTP Network Print Processes Manual — 427528-007
B - 137
FASTP EMS 512 Text Messages
512
proc-num
is the process number (CPU, PIN) of the process.
device-name
is the Spooler device name.
n
indicates the contents of the Start Print command. If n=1, the Start Print command
contained default values. If n=2, the contents of the Start Print command were set
by a CONTROLBUF 100 call in a FONT job.
Cause. This message applies to FASTPXNS only. FASTPXNS encountered an
unexpected XNS Courier protocol problem when attempting to send a Start Print
command to the printer.
Effect. The device is placed offline.
Recovery. If the error persists, contact your service provider as described in
Troubleshooting and Reporting Problems on page 8-1.
512
proc-num
is the process number (CPU, PIN) of the process.
%nnnnnn
is an octal return code from the relevant S
pooler system operation. These return
codes are defined in the Spooler Programmer’s Guide.
spooler-operation
identifies the Spooler operation where the error occurred. The valu
e is one of:
PRINTCOMPLETE on supervisor
PRINTINFO
PRINTINIT on supervisor
PRINTREADCOMMAND
PRINTSTART
proc-num DEV: device-name XNS Start Print Error n
proc-num Error %nnnnnn from spooler-operation