Spooler FASTP Network Print Processes Manual

EMS Messages
Spooler FASTP Network Print Processes Manual — 427528-007
B - 139
FASTP EMS 512 Text Messages
Effect. The FASTP network print process abends and might create a ZZSAnnnn
Saveabend file.
Recovery. Use the Spoolcom DEV command to restart the device. (Depending on the
device configuration, the device might restart automatically.) If the error persists, or the
cause of the error is unknown, contact your service provider as described in
Troubleshooting and Reporting Problems on page 8-1.
512
proc-num
is the process number (CPU, PIN) of the FASTPTCP process.
Cause. Because FASTPTCP processes are started automatically by the Spooler
supervisor using the name configured with Spoolcom PRINT, this message can only
occur when the FASTPTCP process has been improperly started. The most likely
cause is the TACL RUN command was inadvertently used.
Effect. The FASTPTCP process stops.
Recovery. Do not use TACL RUN commands for FASTPTCP processes; use the
normal Spooler mechanism as described in Configuring a FASTP Network Print
Process on page 2-4. If the error persists, contact your service provider as described in
Troubleshooting and Reporting Problems on page 8-1.
512
proc-num
is the process number (CPU, PIN) of the process.
file-err
is the file-system error returned by the Guardian OPEN procedure. See the
Guardian Procedure Errors and Messages Manual for explanations of file-system
errors.
supervisor
is the name of the Spooler supervisor process.
Cause. Because FASTP network print processes are st
arted automatically by the
Spooler supervisor using the name configured with Spoolcom PRINT, this message
proc-num Print process must have valid spooler in IN file
proc-num Unable to OPEN Spool Supervisor, Err: file-err on
supervisor